The 32nd China International Plastics and Rubber Industry Exhibition opened at the Shanghai Hongqiao National Convention and Exhibition Center.

Plastic materials and air are a trade-off. If the moisture in the air (water content) is the moisture content inside the plastic material, the material will slowly absorb the moisture in the air until the inside is saturated.

During the process of dehumidifying the dryer material, the movement of the material particles in the airflow is divided into an accelerated motion phase and a constant velocity motion phase.

The mold temperature control system works by pumping the heat transfer medium from the tank containing the built-in heater and cooler to the mold and back from the mold to the tank.

Most of the engineering plastics of the dehumidifying dryer are hygroscopic.

The operation of the mold cleaning machine must be carried out in accordance with the regulations, in order to avoid unnecessary accidents. How to operate? This is not repeated here. Because it has been said many times before. More repetitions are caused by the impatience of everyone. Below I am goi......